Web Analytics
Datasheet 搜索 > 开发套件 > TI(德州仪器) > DRV8308EVM 数据手册 > DRV8308EVM 产品设计参考手册 5/25 页
DRV8308EVM
934.101
导航目录
  • 原理图在P3P20
  • 焊盘布局在P7
  • 技术参数、封装参数在P8P9P22
  • 应用领域在P25
DRV8308EVM数据手册
Page:
of 25 Go
若手册格式错乱,请下载阅览PDF原文件
www.ti.com
2.3 Power Supply Setup
3 Shutdown
DVDD
SHUTDOWN
>50 sm >50 sm
4 Component Selection
4.1 Charge Pump
Shutdown
To power up the EVM, one power supply is needed. The power supply is connected to the EVM using a
2-pin, 2,54-mm pin header, J10.
Table 2. Recommended Supply Voltage
Description Voltage Limitations Current Requirement Cable
Power supply 5 V 0.25 A
CAUTION
Applying voltages above the limitations given in Table 2 may cause permanent
damage to your hardware.
For minimum click and pop during power on and power off, the shutdown pin should be kept low. The
preferred power-up/down sequence is shown in Figure 4 .
Figure 4. Power-Up/Down Sequence
On the DRV601EVM2, the correct shutdown signal is provided by U95, a TPS3825-33 supply monitor.
The charge pump flying capacitor, C13, serves to transfer charge during the generation of the negative
supply voltage. The PVSS capacitor must be at least equal to the charge pump capacitor in order to allow
maximum charge transfer. Low ESR capacitors are an ideal selection, and a value of 1 µ F is typical.
Capacitor values smaller than 1 µ F can be used, but the maximum output can be reduced. It is therefore
recommended to validate the design with thorough testing.
SLOU217 March 2008 DRV601EVM2 5
Submit Documentation Feedback

DRV8308EVM 数据手册

TI(德州仪器)
29 页 / 1.21 MByte
TI(德州仪器)
25 页 / 1.25 MByte
TI(德州仪器)
59 页 / 1.81 MByte

DRV8308 数据手册

TI(德州仪器)
DRV8308 无刷直流电机控制器
TI(德州仪器)
DRV8308RHAR 编带
TI(德州仪器)
TEXAS INSTRUMENTS  DRV8308RHAT  芯片, 电机驱动器, 三相, 无刷直流, VQFN-4
TI(德州仪器)
TEXAS INSTRUMENTS  DRV8308EVM.  评估板, 用于DRV8308无刷电机
器件 Datasheet 文档搜索
器件加载中...
AiEMA 数据库涵盖高达 72,405,303 个元件的数据手册,每天更新 5,000 多个 PDF 文件