Datasheet 搜索 > 运算放大器 > ADI（亚德诺） > AD8476BRMZ 数据手册 > AD8476BRMZ 用户编程技术手册 1/6 页
器件3D模型￥ 35.569
AD8476BRMZ 用户编程技术手册 - ADI（亚德诺）
制造商:
ADI（亚德诺）
分类:
运算放大器
封装:
MSOP-8
描述:
Analog DevicesAnalog Devices 的差分放大器经过集成和优化，适用于差分信号应用。 这些专业放大器具有固有的共模抑制特性，通过输出增益和相位匹配实现低谐波失真。 应用包括驱动或接收长电缆上的信号、驱动平衡 ADC 输入和查找互补输出。### 差动放大器### 差分放大器，Analog Devices
Pictures:
3D模型
符号图
焊盘图
引脚图
产品图
页面导航:
技术参数、封装参数在P1
导航目录
AD8476BRMZ数据手册
Page:
of 6 Go
若手册格式错乱，请下载阅览PDF原文件
Analog Dialogue 52-12, December 2018
1
Integrated PGIAs
ADI offers a number of integrated PGIAs in its portfolio. Integrated PGIAs
provide the benefit of shorter design time and a smaller footprint. The
digitally adjustable gain is achieved with internal precision resistor arrays.
On-chip trimming of these resistor arrays can be done to optimize gain,
CMRR, and offsets, resulting in good overall dc performance. Design tech-
niques can also be utilized for compact IC layout to minimize parasitics,
as well as provide excellent matching, resulting in good ac performance.
Because of these advantages, it is always recommended to choose an
integrated PGIA, if there is one that meets the design requirement. Table 1
lists available integrated PGIAs along with some key specifications.
The choice of PGIA is dependent on the application. The AD825x is very
useful in multiplexed systems due to its fast settling time and high slew
rate. The AD8231 and LTC6915, which have zero-drift architectures, are
useful for systems where precision performance is required over a wide
range of temperatures.
analogdialogue.com
Introduction
Data acquisition (DAQ) systems find their use in many industries, for a
wide range of applications, such as research, analysis, design verification,
manufacturing, and testing. By nature, these systems interface to various
sensors, which poses a challenge to the front end. Different sensor sensi-
tivities must be considered—for example, a system may need to interface
to a load sensor that has a maximum output of 10 mV and submicrovolt
sensitivity, while also interfacing to a sensor that is preconditioned for
a 10 V output. With a single gain, the system needs to have a very high
resolution to sense both inputs. Even then, signal-to-noise ratio (SNR) is
sacrificed at the lowest inputs.
In these applications, programmable gain instrumentation amplifiers
(PGIAs) are a good solution for the front end to accommodate the sensi-
tivities of the various sensor interfaces, while optimizing SNR. Integrated
PGIAs are available to achieve good dc and ac specifications. This article
discusses the various integrated PGIAs and the advantages in using them.
Limitations will also be discussed, along with guidelines for building a dis-
crete PGIA when trying to meet a specific requirement.
Programmable Gain Instrumentation
Ampliers: Finding One that Works for You
By Kristina Fortunado
Share on
AD825x AD8231 LTC6915
Gain Settings
1, 2, 5, 10 (AD8250) 1, 2, 4, 8 (AD8251)
1, 10, 100, 1000 (AD8253)
1 to 128 in 6 dB steps 1 to 4096 in 6 dB steps
CMRR (G = 1) 80 dB 80 dB 125 dB
Gain Drift 10 ppm/°C 10 ppm/°C
Quiescent Current 4.5 mA 4 mA 2 mA
Bandwidth 10 MHz 2.7 MHz 200 kHz
Settling time 0.78 µs 4 µs
Offset Voltage (G=1) 1.05 mV 45 µV 10 µV>
Offset Voltage Drift 6.2 µV/°C 50 nV/°C 50 nV/°C
Input Bias Current 50 nA 500 pA 10 nA
Noise (G=1) 45 nV/√Hz 66 nV/√Hz 2.5 µV p-p (0.1 Hz to 10 Hz)
Gain Nonlinearity 6 ppm 3 ppm 15 ppm
Rail-to-Rail In No (–V
s
+1) to (+V
s
–1.5) Yes (0.2 V beyond the rails) Yes
Table 1. Programmable Gain Instrumentation Amplifiers Specifications
ADAS3022 ADAS3023 AD7124-8
Description 16-Bit, 1 MSPS, 8-channel DAQ system
16-Bit, 8-channel simultaneous sampling
DAQ system
8-Channel, low noise, low power, 24-bit
Σ-Δ ADC with PGA and reference
Gain Settings 0.16, 0.2, 0.4, 0.8, 1.6, 3.2, 6.4 0.2, 0.4, 0.8, 1.6 1 to 128 in 6 dB steps
CMRR (G=1) 90 dB 95 dB 85 dB
Gain Drift 0.1 ppm/°C 1 ppm/°C 2 ppm/°C
Power (Max Gain)
Conversion Rate (Max Channels)
12 mA
125 kSPS
10.5 mA
125 kSPS
1.2 mA
19.2 kSPS (full power)
Table 2. DAQ System Specifications
器件 Datasheet 文档搜索
AiEMA 数据库涵盖高达 72,405,303 个元件的数据手册，每天更新 5,000 多个 PDF 文件
